To prepare the front edge of the coat, we need two long strips (about 1 cm wide) of lining fabric, cut on bias.
On the lapel, baste the bias stripe onto the hair canvas (in the picture, the tape is placed on the edge of the hair canvas, but not basted yet).
At the waist, make a short cut into the hair canvas and move the bias tape between the outer fabric and the interfacing. Continue reading Test Coat Step V – Lapel and front facing
Finally I get to write a little update here. It’s not that I haven’t made any progress, I just preferred making things to posting about them, due to time restrictions…
I finished the pockets despite, as you will be able to see in the pictures, some problems with my sewing machine, specifically thread tension.
First, I copied the pattern, added the to be folded facing part at the top of the pocket (about 1”) and cut a corresponding piece of lining, as you can see in the second picture.
Continue reading Test Coat Step IV – Pockets
For the most part, making the belt was straightforward – I’m not entirely happy with it, though. You’ll see why, in a minute.
The four belt pieces are identical in shape. I chalked the rounded corners on the wool pieces as well as two pieces of the light hair canvas (believing that interfacing only one of the backing parts of each belt-half ought to suffice… then).
Continue reading Test Coat Step III – The Belt
Finally I have had the time to start work on the coat itself! And it’s very pleasing to do something involving needle and thread and not merely rulers and paper!
Preparing the front pieces
After closing the seam running from the armscye downwards and securing the slit that will later be covered by the pocket, I started, enthusiastically, by padding the hair canvas to the right front piece. Because it interested me. And because I wanted to see the effect this had on the fall of the fabric for myself.
Well. What I should have done before, is a) ironing fusible interfacing on the area where the welt pockets are going to be inserted in the next step, and b) fix the placket in the shoulder area.
As I only realised this after I had completed the padding, I had to remove the whole thing again, of course. Well, it didn’t happen again on the left front piece afterwards…
The closed side dart and the horizontal cut covered by fusible interfacing. You can also see the area where the welt pocket will go, which I have also doubled with the same light, woven fusible.
Continue reading Test Coat Step I – The Front Pieces and The Welt Pockets
This has only partly been in coming so long because of, well, procrastination on my part… I had to switch to an older camera that’s got severe connectability issues with anything newer than XP. But now it’s running just fine, so I can properly update again.
All right. First of all, a picture of the collection of different hair canvases and other interfacings I ordered for trying out on the test coat:
I’ll add more specific description when I get to using them… Most are the sew-in variant, but there are also two fusibles I might try on smaller bits and pieces.
Continue reading Cutting outer fabric and a bit of hair canvas…
Okay. This has taken me inexcusably long due to different RL issues, including the cold in my sewing room… But I’ve finally finished the first set of the tissue pattern.
I cut seperate patterns for the following outer fabric pieces: belt, pockets, upper and under collar, upper and under collar stand; plus patterns for the front facing and hair canvas interfacing.
I have not cut patterns for upper and under sleeves, cuffs, all the lining (and the intermediate lining I am still considering) or the placket, yet.
So, here goes: Continue reading Tissue paper pattern! (Part 1)